SGI Ethernet Card Guía de usuario descargar pdf (Pagina 35)

Verifying Functionality

007-5472-001 17

Verifying Board Recognition

To verify that the operating system has located the Gigabit Ethernet board, use the Linux

PCI utilities lspci(8) command, as follows:

% lspci

...

0b:04.0 Ethernet controller: Broadcom Corporation NetXtreme BCM5715 Gigabit Ethernet (rev a3)

0b:04.1 Ethernet controller: Broadcom Corporation NetXtreme BCM5715 Gigabit Ethernet (rev a3)

In 0b:04.0 Ethernet controller identification, 0b is the bus number, 04 is the

slot number, and 0 is the port, respectively.

Verifying Board Conﬁguration and Enabling

Use the installation tool that comes with your operating system to install and conﬁgure

the Ethernet board.

You can use the ifconfig -a command to verify the conﬁguration information, as

follows:

Table 3-2 LEDs on the Copper Gigabit Ethernet PCI Express Board

Components Purpose

LEDs Three LEDs per port

Link/Activity: Turns on any link speed, blinks on activity (green)

100Mbits/s: Turns on 100 Mbit/s link (green)

1000 Mbits/s: Turns on 1000 Mbit/s link (green)

LEDs are located on the Copper board visible through holes in the

metal bracket holder.

Connectors Four shielded RJ-45

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 51 52

Sin comentarios

SGI Ethernet Card Guía de usuario Pagina 35