SGI UV 2000 Guía de usuario Pagina 38

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 110
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 37
20 007-5832-001
1: Operation Procedures
Power off a UV System
To power down the UV system, use the power off command, as follows:
CMC:r1i1c> power off
==== r001i01c (PRI) ====
You can also use the power status command, to check the power status of your system
CMC:r1i1c> power status
==== r001i01c (PRI) ====
on: 0, off: 32, unknown: 0, disabled: 0
The following command options can be used with the power off|down command:
usage: power [-vo] off|down [system-SSN]...turns power off
-v, --verbose verbose output
-o, --override override partition check
Additional CLI Power Command Options
The following are examples of command options related to power status of the system IRUs.
These commands and arguments can be used with either the SMN or CMC CLI.
usage: power [-vchow] reset [system-SSN]...toggle reset
-v, --verbose verbose output
-c, --clear clear EFI variables (system and partition
targets only)
-h, --hold hold reset high
-o, --override override partition check
-w, --watch watch boot progress
usage: power [-v] ioreset [system-SSN]...toggle I/O reset
-v, --verbose verbose output
usage: power [-vhow] cycle [system-SSN]...cycle power off on
-v, --verbose verbose output
-h, --hold hold reset high
-o, --override override partition check
-w, --watch watch boot progress
Vista de pagina 37
1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 109 110

Comentarios a estos manuales

Sin comentarios