SGI InfiniteStorage 4000 Series Guía de usuario Pagina 35

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 122
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 34
The Disk Drives
007-4834-001 17
The Disk Drives
Each storage enclosure can contain up to 16 low-profile Fibre Channel disk drives.
Controller enclosures can be cabled to as many as six expansion enclosures for a total
capacity of 112 disks in one storage system. Each disk is mounted in a sled for ease of
installation and removal. These drive sleds have a lever and latch mechanism that allows
you to cam the drive in and out of the enclosure.
Each drive has three status LEDs (see Figure 2-4) as follows:
LED 1 is the drive service action allowed indicator: This LED is normally off
showing it is OK to remove the drive. It illuminates green when a problem status
indicates the drive should not be removed.
LED 2 is the Drive fault indicator: The normal status of this LED is off, although it
will blink during drive volume or storage array locate functions. If this LED
illuminates solid amber, then there is a problem with the drive.
LED 3 is the drive active indicator: It blinks when data is being processed and stays
on steadily when the drive is on but no data is processing. If it is off, there is no
power to the drive, or, the drive is not seated properly in the slot.
Figure 2-4 Disk Drive Locations and Status LEDs
RAID Controllers
Each SGI InfiniteStorage 4000 controller enclosure contains two RAID controller
modules. These controllers slide into the same opening that the ESMs occupy on the
expansion enclosures. Each controller contains RAID logic, cache memory, a
rechargeable battery for the cache, and additional environmental monitoring circuitry.
Vista de pagina 34
1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 121 122

Comentarios a estos manuales

Sin comentarios