SGI InfiniteStorage 4000 Series Guía de usuario descargar pdf (Pagina 58)

40 007-4834-001

3: Operating Storage Enclosures

Reinstalling the Enclosure

If you are installing the enclosure in another location in the rack, (or in another rack) use

the following mounting rail tips as applicable:

• Attach the support rails to the new location in a rack. For more information, refer to

the installation instructions included with your support rails.

• If you are installing the rails above an existing module, position the rails directly

above the module.

• If you are installing the rails below an existing module, allow 13.3-cm (5.25-in.)

clearance for a drive module or RAID controller module.

To reinstall the enclosure into a rack, follow these steps:

1. Install the support rails in the rack.

2. From the front of the rack, slide the enclosure into the rack along the support rails.

3. Fasten the rear and front mounting screws (see Figure 3-6 on page 38).

4. Wearing antistatic protection, reinstall the components into the enclosure. See

Chapter 4, “Replacing Enclosure Components” for more information.

5. Slide the top of the front bezel over the indicator lights and snap into place. If your

enclosure comes with an air filter installed in the bezel, check it using the

information in “Front Bezel Air Filter” on page 41.

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 121 122

Sin comentarios

SGI InfiniteStorage 4000 Series Guía de usuario Pagina 58