SGI InfiniteStorage 4000 Series Guía de usuario descargar pdf (Pagina 59)

Front Bezel Air Filter

007-4834-001 41

Front Bezel Air Filter

Use the following procedures to check, replace, or clean an air filter installed in the bezel

of your InfiniteStorage 4000 RAID controller or disk expansion enclosure.

Under certain conditions you may need to clean or replace the air filter in your RAID

enclosure (callout 3 in Figure 3-7) as often as every three months.

Removing and Replacing the Filter

Use the following steps to replace the bezel filter:

1. If the enclosure’s bezel (callout 1 in Figure 3-7) has not already been removed, grip

the ends and remove it from the front of the unit.

2. Before removing the filter (callout 2 in Figure 3-7) note the position of the bezel’s

screen frame and how the filter sits in the frame.

Figure 3-7 Bezel Air Filter Replacement

3. Remove the screen frame (callout 1 in Figure 3-8) and filter from the back side of the

enclosure’s front bezel.

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 121 122

Sin comentarios

SGI InfiniteStorage 4000 Series Guía de usuario Pagina 59