
56 007-4834-001
4: Replacing Enclosure Components
9. Close both levers until the latch locks into place.
10. Install the SFP transceivers and Fibre Channel interface cables in their original
locations.
11. Check the power and fault indicators on the new module.
• If the power indicator is off, the module may not have been inserted correctly.
Remove the module and reinsert it.
• If the fault indicator is on, the power indicator stays off, or any other fault
indicator is on, use TPSSM to determine the problem.
12. See TPSSM for instructions on bringing the environmental status module online.
Figure 4-8 Removing and Installing an Environmental Status Module
Comentarios a estos manuales