SGI IS2224 Manual de usuario descargar pdf (Pagina 16)

Installing the Storage Enclosure . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

2-6 620J Storage Enclosure Installation and Overview Guide

Figure 2–4 Alignment Spacers on the Mounting Rail

1 Alignment Spacers

d Insert one M5 (12mm) screw through the front of the cabinet, and screw into

the top captured nut in the mounting rail.

e Insert two M5 (12mm) screws through the rear of the cabinet and screw into

the captured nuts in the rear flange in the mounting rail.

f Tighten the adjustment screws on the mounting rail.

g Repeat substep a through substep f to install the second mounting rail on the

other side of the cabinet.

6 With the help of one other person, slide the rear of the storage enclosure onto the

mounting rails. The rear edge of the storage enclosure must fit into the clip on the

mounting rail. The storage enclosure is correctly aligned when these conditions are

met on both mounting rails:



The mounting holes on the front flanges of the storage enclosure align with the

mounting holes on the front of the mounting rails.



The rear edge of the storage enclosure sheet metal fits into the clip on the

mounting rail (Figure 2–5 on -page 2-7).



The holes in the storage enclosure sheet metal for the rear hold-down screws

align with the captured nuts in the side of the mounting rails.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 45 46

Sin comentarios

SGI IS2224 Manual de usuario Pagina 16